1. Necessary tools. | 2. The bevel is cut off (angle 15˚). | 3. The gluing border is being marked. |
4. Primer is applied to the inner surface of the fitting. | 5. Primer is applied to the pipe. | 6. Primer is applied to the end of the fitting. |
7. Glue is applied to the pipe in an even layer. | 8. Glue is applied to the inside of the fitting in a thin, even layer. | 9. A control layer of glue is applied to the surface of the pipe. |
10. Fitting and pipe are connected by pushing and turning 1/4 turn. | 11. This position is held for 30 seconds. | 12. Remaining glue is removed. |